Ashveera Pneumatic Services (Chennai) Private Limited

Vertical Air Receiver is engineered to handle the stress of fluctuating air demands, reduce wear and tear and increase the life of the end-use equipment.

Note: For more models, kindly visit the attached PDF.

Ozone-friendly refrigerant:

We think long run to make the earth and the environment a safer and better place to live. As per international protocol, Elgi uses ozone-friendly R134A gas as the refrigerant which has zero ozone-depletion potential.

 

Features:

• Abrasion resistance
• Longer service life
• Resistance against rust
• Ozone-friendly
• Low-pressure drop
• Non-cyclic
• Compact
• Suitable for 180-260/415 V
• Environment-friendly R 134A
• Tropicalised

Note: For more models, kindly visit attached PDF.

The Alocrom aluminum treatment is a special feature of all ELGi Compressor Air Filter die-cast filter housings. This treatment ensures there is no corrosion and no carryover of corroded particles into the airline, which can otherwise cause blockades in sophisticated parts.

These air filters are divided into three types:

• TYPE PF (PreFilter): High-efficiency General Purpose Protection, For the removal of particles down to 1 micron including coalesced liquid water and oil, providing a maximum remaining oil aerosol content of 0.5 mg/m3@ 21°C.

• TYPE FF (Fine Filter): High-Efficiency Oil Removal Filtration, For the removal of particles down to 0.01 micron including water and oil aerosols, providing a maximum remaining oil aerosol content of 0.01 mg/m3@ 21cC. (Precede type FF with type PF)

• TYPE CF (Carbon Filter): Activated Carbon Filtration, For the removal of oil vapour and hydrocarbon odour giving a maximum remaining oil content of <0.003 mg/m3 (<0.003 ppm) (excluding methane) @ 21°C. (Precede type CF with type FF & PF).

 

Note: For more models, kindly visit attached PDF.

Depending on the humidity level of the inlet air, a certain amount of bulk water is present in the compressed air at varying levels. This bulk water causes the corrosion of pipes, end tools, machinery and valves. This unique centrifugal type moisture separator with automatic drain removes over 99% of bulk water from the compressed air, resulting in corrosion-free, longer life of end-use equipment and less load on the dryer. Fixed vortex generator for improved water removal by centrifugal and impingement separation.

 

Features:

• Easy installation
• High load bearing capacity
• Reliable operation

Note: For more models, kindly visit attached PDF.

To meet the diverse requirements of our clients, we are involved in offering a wide range of Compressor Pre Filter. These products are well equipped and are highly demanded by our clients. These products are well known for their traits like optimum strength, smooth functioning and dimensional accuracy. Our products are durable and cost-effective.

It is a surprising fact that 100% of the electrical power (energy) is converted to heat energy during the Compression process In an Air compressor & all the heat energy goes as a waste if not used judicially. In a typical compression system, the theoretical recoverable heat is 96% of the overall electrical energy consumption. It consists of heat dissipated in the oil cooler (78%) the air cooler (13%) and the heat radiated from the drive Motor (5%). The rest 4% heat cannot be recovered since 2% radiates through the canopy and the other 2% vents inside the canopy.

Keeping in mind the effects of Global warming in the present environment. ELGi has come up with a system where in 96% of the waste heat generated from the compressor can be utilized for heating air (space) and heating water. This in turn eliminates the necessity to go for an additional equipment to heat water or Air, there by reducing the CO2 emission to a larger extent.